Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
696
Evan is correct, using two layers of heat-shrink does not work, it is too thick. A single layer on the base of the LED near the flange works fine.
Clay, your photo looks good for the layout of the resistors and respective measurements. If you are doing the ACA Premium parts build, note that some of the resistor values will change, notably R11 and R12 to 20K and 90.9K, respectively.
The supplied bridging resistor (shown here at 39K) is too short to reach from the lower right switch terminal to the left channel output. Also, it is not at all clear WHY the 39K bridging resistor from the switch used to go to the INPUT of the R channel RCA in ACA v1.6, but now, in V1.8, goes to the Negative terminal of the L channel OUTPUT (speaker bnding post). Please explain.